"Remote controller does not turn on (no red LED)"

 - Cause: Batteries are not inserted correctly.
 - Fix: Make sure they are inserted correctly. Refer to manual for correct orientation.
 - Cause: Batteries are dead.
 - Fix: Replace with new batteries.

"Helicopter will not turn on (no lights on)"

 - Cause: Switch not turned to “ON” position.
 - Fix: Switch from “OFF” to “ON” position.
 - Cause: Battery has not been re-inserted into the side of the helicopter after charging.
 - Fix: Re-insert battery plug into side of the helicopter after charging.

"Helicopter/Remote will not sync to each other"

 - Cause: Either helicopter or remote is OFF.
 - Fix: Make sure both are in the ON position.
 - Cause: Batteries are weak in remote.
 - Fix: Change batteries.

"Helicopter will not lift off"

 - Cause: Battery is not charged.
 - Fix: Recharge battery.
 - Cause: Rotor blades are damaged.
 - Fix: Replace rotor blades.

"Helicopter loses sync and causes loss of control"

 - Cause: Remote antenna NOT installed.
 - Fix: Replace antenna if damaged or install antenna that was included in the Litehawk packaging.
 - Cause: Batteries in remote are weak.
 - Fix: Replace with new batteries.
 - Cause: Went out of range.
 - Fix: Keep within 30meters from remote control.

This is simply a "Quick Trouble Shooting Guide" for LiteHawk AERO.

Rest assured, we will have you flying again!

LiteHawk Canada
50 Konrad Crescent
Markham, Ontario
L3R 8T4
Canada

1-800-268-5797 
litehawk@borgfeldt.ca


Last Edited By: Litehawk D 02/09/2012 8:30 PM. Edited 1 time.