Remote controller does not turn on (no red LED)
- Cause: Batteries are not inserted correctly.
- Fix: Make sure they are inserted correctly /proper orientation.
- Cause: Batteries are dead.
- Fix: Replace with new batteries.
Helicopter will not turn on (no lights on)
- Cause: Battery is Dead
- Fix: Recharge battery.
Helicopter/Remote will not sync to each other
- Cause: Either helicopter or remote is OFF.
- Fix: Make sure both are in the ON position.
- Cause: Batteries inside remote are dead or dying.
- Fix: Replace with fresh batteries
Helicopter will not lift off
- Cause: Battery is not charged.
- Fix: Recharge battery.
Tail rotor does not work
* Please note that the tail rotor will only be operational once pitching forward or reverse. When stationary (blades not spinning), the tail rotor will be inoperable
- Cause: Tail rotor is too tight allowing for it to make contact with the plastic housing.
- Fix: Make sure there is .5-1mm gap between tail rotor bade and plastic housing.
Helicopter loses sync and causes loss of control
- Cause: Batteries in remote are dead/dying.
- Fix: Replace batteries with fresh ones.
- Cause: Flying in direct sunlight, bright lights, or in front of T.V screens.
- Fix: Keep from flying in these areas.
- Cause: Facing opposite direction than helicopter.
- Fix: Always fly with remote pointed in direction of the helicopter.
- Cause: Helicopter is flown too far from remote.
- Fix: Keep within 10 metres when flying your LiteHawk II.
This is simply a "Quick Trouble Shooting Guide" for LiteHawk II.
Rest assured, we will have you flying again!
LiteHawk Canada
50 Konrad Crescent
Markham, Ontario
L3R 8T4
Canada
1-800-268-5797
litehawk@borgfeldt.ca
